Design considerations and initial performance of a 1.2 cm/sup 2/ beta imaging intra-operative probe

Abstract

A novel small area beta (/spl beta//sup /spl plusmn//) detector is under development for nuclear emission imaging of surgically exposed, radiolabeled tumor beds. The imaging device front-end consists of a 0.5 mm thick by 1.25 cm diameter CaF/sub 2/(Eu) scintillator disk coupled to a rigid bundle of 2 mm diameter double clad optical fibers through a polystyrene light diffuser. The detector area (1.2 cm/sup 2/) was determined by the requirement of introducing the probe into small cavities, e.g. during neuro-surgical lesion resection, but large enough to produce images of clinical significance. Flexible back-end optical fibers (1.9 m long) were coupled to the front-end components allowing /spl sim/75 photo-electrons to be detected for mean beta energies of 250 keV, indicating that sufficient signal can be obtained with clinical beta emitters (e.g. /sup 18/F, /sup 131/I). The long flexible fibers guide the scintillation light to a Philips XP1700 series, fiber optic faceplate, Multi-Channel PMT. The parallel MC-PMT outputs are fed into a variable gain, charge divider network and an i-V pre-amplifier/line driver network, whose resulting four outputs are digitized and histogrammed with standard Anger positioning logic. The various components in the imaging chain were evaluated and optimized by both simulations and measurements. Line spread functions measured in the 10.8 mm FOV were 0.50 mm /spl plusmn/0.038 mm and 0.55 mm /spl plusmn/0.065 mm FWHM in X and Y, respectively. A 20% variation in pulse height and minimal variation in spatial resolution was observed. The differential image uniformity was measured to be /spl plusmn/15.6% with /spl sim/150 cts/pixel. Preliminary images show excellent reproduction of phantom activity distributions.