Abstract
Strain gage pressure transducers are most frequently used for soil stress state determinations. Their construction, rugged and mechanically resistant, enables them to measure stresses within a wide range (up to 500 kPa) in harsh conditions. Output signals are easily readable and stable. The accuracy of the measurements, however, depends upon proper design and calibration before use in soil. This paper contains information on design considerations and results from calibration tests of transducers of two membrane diameters: 20 and 30 mm. The calibration test stand, as well as calibration procedures, are described in detail. For calibration tests, natural soils were used, as well as steel balls, to simulate the effect of the aggregated structures of arable soils and grain materials. The calibration method considered different soil types as well as soil water content. Soil and its water content were found to have an effect on output scale factor.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
