Abstract
This paper presents the Design, Simulation and characterization of Printed Micro strip Low Pass Filter based on 15 mil Alumina substrate. Simulations show a comparison between a pure EM simulation with EM Sight and a more efficient hybrid approach that combines EM analysis (using X-Models) with conventional circuit simulations and both approaches match the measured data. Furthermore, the proposed paper has four different low pass filter designs, lumped design; basic designs uses only micro strip lines; advanced design uses multiple edge coupled micro strip lines, EM sight design provides a very sharp cut-off frequency response with low insertion loss, results having great agreement with excellent correlation. Tuning and Optimization of the design is carried out using AWR Microwave office tool.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Research in Engineering and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
