Design and sample size determination for multiple-dose randomized phase II trials for dose optimization.

Abstract

The U.S. Food and Drug Administration (FDA) has launched Project Optimus to shift dose selection from the maximum tolerated dose (MTD) to the dose that produces the optimal risk-benefit tradeoff. One approach highlighted in the FDA's guidance involves conducting a randomized phase II trial following the completion of a phase I trial, where multiple doses (typically including the MTD and one or two doses lower than the MTD) are compared to identify the optimal dose that maximizes the benefit-risk tradeoff. This article focuses on the design of such a multiple-dose randomized trial, specifically the determination of the sample size. We generalized the standard definitions of type I error and power to accommodate the unique characteristics of dose optimization and derived a decision rule along with an algorithm to determine the optimal sample size. The resulting design is referred to as MERIT (Multiple-dosE RandomIzed Trial design for dose optimization based on toxicity and efficacy). Simulation studies demonstrate that MERIT has desirable operating characteristics, and a sample size between 20 and 40 per dosage arm often offers reasonable power and type I errors to ensure patient safety and benefit. To facilitate the implementation of the MERIT design, we provide software, available at https://www.trialdesign.org.