Design and qualification tests of a robotic joint module for tokamak in-vessel manipulator use

Abstract

PurposeThis paper aims to present the design and a prototype experiment of a robotic joint module for tokamak in-vessel manipulator-related research; the results will promote the adaptation of current in-vessel inspection manipulator to achieve full tokamak in-vessel environment compatibility.Design/methodology/approachA flexible metallic bellow-enclosed working chamber is used to protect the main servo drive components, the active cooling method for high temperature protection and the servo control structure simplification for high radiation endurance. A joint module prototype is manufactured and tested under a similar in-vessel environmental condition for extreme condition protection validation and basic servo control ability evaluation.FindingsThe joint module prototype successfully survived the similar in-vessel environment tests and proved good mobility via closed-loop servo control. A conceptual design of a serial linkage manipulator with joint module structure is proposed for future in-vessel inspection manipulator development.Originality/valueThe proposed joint module uses common industrial servo components to achieve its full extreme in-vessel environment compatibility. Different from traditional metallic bellow application in a vacuum environment to produce a linear movement result, the proposed joint module aims to achieve rotating movement directly from the metallic bellow structure, thereby reducing the joint structure space requirement, simplifying the vacuum environment movement transmission structure and increasing the vacuum environment compatibility degree.