Abstract
In a surface transverse wave (STW) asynchronous resonator, grating phase shifters are placed between interdigital transducers and reflectors to obtain the incident and reflected waves in phase, and the resonance frequency is located near the center frequency of the reflectors. In this paper, the scattering matrix method is used for design of such resonators with one dominant longitudinal mode. At a frequency of about 509.5 MHz, insertion loss, and loaded and unloaded quality factors of about 6 dB, 5,300 and 11,000, respectively, were obtained. The measured and calculated parameters of this resonator are in good agreement. Design guidelines and comparison of synchronous and asynchronous resonators are presented. Compared to synchronous resonators, low spurious signals' level, location of the resonance frequency near the center frequency of the reflectors, and simple design method make the asynchronous resonators more attractive for manufacture and practical applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
