Design and performance of a slender soft continuum manipulator for tall structure inspection

Abstract

PurposeThe current methods for inspecting tall or deep structures such as towers, chimneys, silos, and wells suffer from certain constraints. Manual and assisted inspection methods including humans, drones, wall climbing robots, and others are either costly, have a limited operation time, or affected by field conditions, such as temperature and radiation. This study aims to overcome the presented challenges through a teleoperated soft continuum manipulator capable of inspecting tall or deep structures with high resolution, an unlimited operation time and the ability to use different arms of the manipulator for different environments and structure sizes.Design/methodology/approachThe teleoperated manipulator uses one rotary and two tendon actuators to reach and inspect the interior of a tall (or deep) structure. A sliding part along the manipulator’s body (arm constrainer and tendon router) induces a variable-length bending segment, allowing an inspection camera to be placed at different distances from the desired location.FindingsThe experiments confirmed the manipulator’s ability to inspect different locations in the structure’s interior. The manipulator also demonstrated a submillimeter motion resolution vertically and a 2.5 mm per step horizontally. The inspection time of the full structure was 48.53 min in the step-by-step mode and was calculated to be 4.23 min in the continuous mode.Originality/valueThe presented manipulator offers several design novelties: the arm’s thin-wide cross-section, the variable-length bending segment in a fixed-length body, the external rolling tendon routing and the ability to easily replace the arm with another of different material or dimensions to suite different structures and environments.