Design and performance evaluation of a novel parallel kinematic micromanipulator

Abstract

The targeted placement of selected carbon nanotubes is associated with low throughput rates. Hence, this paper presents a novel stage design for the fully automatic assembly of carbon nanotube field-effect transistors (CNTFETs) via mechanical dry transfer. It constitutes the core module of an assembly machine for the precise deployment of nanotubes onto a prefabricated wafer. The mechanical dry transfer approach allows high level of carbon nanotube selectivity with the aim of enabling a high-volume fabrication of ultra-clean devices. The previous production rate of such ultra-clean devices is less than one per hour, which offers a high potential for improvement. The stage consists of a parallel kinematic mechanism (PKM) with 3 degrees of freedom (X2Y2C1) carrying two additional stacked axes (Z1C2). The PKM is suspended on a vacuum preloaded aerostatic bearing, voice coil motors (VCM) and flexure hinges. Together with a combination of high precision and resolution touch probe measurement systems close to its tool center point (TCP), high accuracy and low settling time can be achieved. Based on realistic manufacturing tolerances, a sensitivity analysis of the mechanism’s pseudo rigid body model (PRBM) suggests a theoretical closed-loop error below 0.15μm over the entire XY workspace of 20mm×2.8mm. Measurements of positioning motions show that the settling time can be decreased by the compensation of friction resistances inside the internal bearings of the VCMs.