Abstract
This paper aims at improving the design of torque sensor used in the EPS system. Such design not only integrates the torque and the corner signal, but also saves space. By using Matlab interior point method, the gear system parameters are optimized andthe weight and the size of the sensor are reduced. Bench test results demonstrate that the measurement accuracy of this self-designed sensor is able to meet the demands of EPS.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
