Abstract
With the rapid development of computer network technology, Network Control System has gradually become a hot point in the control field. AT91RM9200 micro-processor, CC2530 RF chip, DC motor and optical encoders were used to build a miniature embedded networked control system. Then some embedded software developments and also control algorithm were designed to make sure that the system can control the motor through a wireless network. Finally, network transmission test and control experiment were conducted to observe the actual network traffic conditions. In the Motor non-load condition, the local control effect was compared to the networked control to get made a series of experimental data, and these data were analyzed and summarized.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Earth and Environmental Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
