Abstract
Electrical Discharge Machining process has been widely used for manufacturing micro components due to its contactless process. Its application has also been introduced in machining micro pits on hip implant. In this paper, a new design of power generator is proposed in order to reduce micro crack while machining take place. Flyback Switch Mode Power Supply has been chosen because of its high efficiency. The simulation of Flyback converter using LT Spice is presented. The result shows that the system achieves 95.9% of efficiency. Experimental results show that flyback converter able to produce DC voltage up to 111.6 V.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
