Abstract
AbstractIn this study, passive edge filter design was implemented by using I‐6, I‐25, M‐5, M‐12 erbium‐doped fibers. For this purpose, first the highest bandwidth and the steepest slope regions of the erbium‐doped fibers were determined in the simulation environment. The experimental setup was realized by using the most appropriate lengths of erbium‐doped fibers found in the simulation study. For I‐25 erbium‐doped fiber, an edge filter with a bandwidth of 32.8 nm and a slope angle of 50.77° was obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.