Abstract
The purpose of this project was to design and test a new bolt-down bollard system that meets the requirements of American Standards for Testing Materials (ASTM) Designation F2656-15 M50/P1 impact conditions. The test installation consisted of three vertical 10-in. diameter (nominal) bollards with welded base plates bolted to a shallow reinforced concrete foundation. The foundation for this system was sized to reduce the foundation embedment. Shallow foundations are often necessary for use in cities and urban areas where utilities can conflict with deeper foundations. Standard common members and materials were used in the installation to accommodate fabrication and installation in locations all over the world. The bollards can be removed to provide access if necessary. Full-scale testing was performed on the bolt-down bollard system. The bollard system design for this project successfully met the requirements of M50/P1 with a total payload penetration of less than 1 m. The new bollard design successfully met all the performance requirements for ASTM F2656-15 M50/P1. Details of the design and testing of the bolt-down bollard system are provided in this paper. Crash-testing videos and additional information on the design and full-scale testing will be provided in the presentation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transportation Research Record: Journal of the Transportation Research Board
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
