Abstract
We investigated the feasibility of designing and fabricating novel broadband radiofrequency (RF) absorbers for use in cavity-backed antennas. Fabricating the absorber involved a multi-material additive manufacturing (AM) approach that combined two polymer filaments: a low-loss dielectric filament and a lossy carbon-loaded filament. An iterative optimization algorithm was developed to deploy these filaments and create gradient distributions of material properties that minimize reflectance over a desired frequency band and a range of incident angles to achieve wideband electromagnetic absorption. The chosen material profiles were effectively realized using a spatially varying subwavelength lattice structure printed via fused filament fabrication. Experimentally, validation results demonstrated low reflectance over a wide frequency band, 10 to 40 GHz, and a range of incident angles, 0°–50°. Finally, this printed multi-material absorber was integrated within a cavity-backed spiral antenna and used to suppress backlobe radiation while maintaining an acceptable radiation pattern in the forward direction. While this study investigated cavity-backed antennas, these computational and experimental methods are potentially useful for a wide range of other applications.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
