Design and Development of Low-Level Automation for the Picking and Placing of the Object Using Pneumatic Suction

Abstract

Pneumatics suction is being used in the food factory for picking and placing the ingredients of food. A clean environment inside the food factory is very much needed the maintain the quality of packaging food. The present work focuses on the low level of automation so that investment cost for processing the raw ingredient goes down. Two double-acting pneumatic cylinders, one pneumatic suction gripper, three pneumatic direction control valves, one screw compressor, one DC motor, two relays, a Push button, and a 24-volt power supply have been used the implement the system. A combination of pneumatic actuation and electrical actuation is used for controlling the motion of the system. A simple control ON/OFF system was used for the actuation. Pneumatic component drive with the help of compressed air via a direction control valve and motor direction control using the relay. By pressing the push button whole, the setup can be controlled in a very easier way and it is very user-friendly for the operator. Several testings have been done on the setup and an excellent result were obtained during execution.