Design and development of latex cup collector robot

Abstract

Global rubber production has declined over the past few years as a result of a number of variables, including both environmental and human factors. In this paper, an automated robot prototype that collects latex cups was developed to improve global rubber production by assisting workers in rubber plantations. The robot was built on a mobile platform with a motorized Five Degrees of Freedom (DoF) robotic arm, Ackermann steering, double wishbone suspension, rear-wheel drive and a latex storage tank to store the latex collected from the trees. The robot was equipped with ultrasonic sensors and a camera module to locate latex cups and rubber trees so that it could move and perform tasks accurately. In addition, encoder sensor modules were used to improve the accuracy of the movements by measuring the rotational speed of the motors. The yield strength of the PLA plastic material used in developing the latex cup collector robot is 7.00 x 107N/m2 and the maximum stress of the critical parts should not exceed the maximum yield strength of the PLA plastic. In mobility test, the robot is able to travel through obstacles of 10mm and 15mm height. The topple angle of the robot in the balancing test is greater than 37°, ensuring the stability of the robot.