Abstract

This paper presents the design and development of a boost converter by using a resistive load. A booster converter is the most popular application in the industry to step up the direct current (DC) input voltage. This study focuses on determining the suitable value of the inductor and capacitor for use in the circuit. Then, this design focuses on continuous mode operation, with different voltage inputs of 9V and 15V DC, where the switching frequency input is 25kHz using the MOSFET as a switching device. The evaluation of this circuit design is to control the input voltage to keep the output voltage maintained at 24VDC. This analysis also uses a ripple inductor current, not more than 25% of inductor current, and output voltage ripple is less than 1%. The parameters for design circuits based on the output voltage, inductor voltage, and inductor current waveform. The design of this circuit will be analyzed using MATLAB Simulink software to verify the results between simulation and theoretical. Based on the simulation results prove that the developed model can maintain the output voltage by using different voltage input values. Finally, a boost converter circuit can be developing by using these parameters.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.