Design and Characterization of an Isokinetic Sampling Train for Particle Size Measurements Using Emission Gas Recycle

Abstract

A particulate sampling train has been constructed which satisfies the conflicting requirements of isokinetic sample extraction and constant flow rate through an inertial sizing device. Its design allows a variable fraction of the filtered emission gas to be added to the sample upstream of the inertial sizing device in order to maintain a preselected flow rate through this device while the gas flow rate into the sampling nozzle is adjusted to remain isokinetic with the local duct velocity. The prototype emission gas recycle (EGR) train was constructed by relatively simple modifications of a commercially available Method 5 sampling system, and much of the sampling technique is identical with Method 5 protocol. The train was tested by comparison of parallel runs in the EPA/SRI wind tunnel using redispersed fly ash. In one series of runs performed without inertial sizing devices, the EGR train and a colocated non-EGR train sampled 3-point traverses. The differences of the average mass concentrations measured by the two trains was 3.3%, with a standard deviation of 4.7%. In the next series of runs, identical cyclone inertial sizing devices were added to each train. The difference of the average mass concentration for these runs was 1.2%, with amore » standard deviation of 5.7%.« less