Abstract
The design and assessment of a flexure-based parallel micromanipulator with two-degrees-of-freedom (2-DOF) for automatic cell injection is presented in this paper. The design and modeling of the micromanipulator are conducted by employing compliance matrix method. The dynamic modeling and analysis via Lagrange equation are conducted to improve the bandwidth of the mechanism. Both theoretical analysis and finite element analysis (FEA) results well validate the good performance of the micromanipulator which will be applied to practical cell manipulations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.