Abstract
Design and Analysis of Mixed Flow Pump Impeller
Highlights
Literature reviewWislicensus (1965) started the design of a mixed flow pump impeller. The changes of mixed flow pump impeller were performed by Myles (1965)
A pump is a device that moves liquids or gases, sometimes slurries, by mechanical action
The changes of mixed flow pump impeller were performed by Myles (1965)
Summary
Wislicensus (1965) started the design of a mixed flow pump impeller. The changes of mixed flow pump impeller were performed by Myles (1965). [1] The mixed flow pump impeller was designed for discharge head developed, speed of rotation. Once the design parameters such as blade angle, blade stagger angle, blade chord length, were calculated, the development of complex shaped blades were carried out by superimposing the various blade sections one over another to satisfy blade stagger angle on the conical surface of the pump impeller. [4 ]Kiran Patel et al, studied the CFD analysis of mixed flow pump derived that the Head predicted by CFD analysis is higher than the test result at rated point. The rotation speed and the main impeller dimensions, namely the exit diameter and width D2 and b2, as well as the blade inlet and exit angles, β1 and β2, respectively, determine the nominal head and and volume flow rate of the impeller. @ IJTSRD | Unique Paper ID - IJTSRD23305 | Volume – 3 | Issue – 3 | Mar-Apr 2019
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have