Abstract
Abstract. This paper analyzes the relationship between the parameters of CFH (Cosine Flexure Hinge) and the adjustable angle in the measurement and micro-adjustment of yaw, pitch and roll angle in the DCM (Double Crystal Monochromator). We derive the motion equations of CFH during the measurement and adjustment process, and get accurate expression formulas. Then we use ANSYS software to simulate the CFH and compare the simulation value and the theoretical value. It shows that the maximum angular deflection error is less than 3.5 percent. We compare the CFH to the RCFH (Right Circular Flexure Hinge), and get that the maximum angular deflection and the linear displacements of RCFH are all about 1.56 times than the CFH when the parameters are equivalent. Therefore, we provide a simple flexure hinge to improve the stability and accuracy of angular measurement and micro- adjustment in the DCM.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.