Abstract
This project presents the modification and analysis of two stent designs based on an existing design. The modifications were made using SolidWorks, followed by ANSYS analysis to evaluate von Mises stress and strain, stress intensity, maximum principle stress, and total deformation. Design Expert was then utilized, employing the Response Surface Methodology (RSM) Box-Behnken method, to conclude the design.The generated ANOVA table enabled the identification of significant factors and interactions. Residual analysis was conducted to assess the model's fit and accuracy. The abstract highlights the iterative design process involving SolidWorks, ANSYS, and Design Expert, emphasizing the use of ANOVA and residual analysis to improve the stent design. The optimized stent designs exhibited improvements in stress distribution, strain, stress intensity, and deformation characteristics. This integrated approach utilizing SolidWorks, ANSYS, and Design Expert holds promise for enhancing stent performance and optimizing patient outcomes.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: international journal of engineering technology and management sciences
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
