Abstract

A 24 GHz high linear, high-gain up-conversion mixer is realized for fifth-generation (5G) applications in the 65 nm CMOS process. The mixer’s linearity is increased by applying an Improved Derivative Super-Position (I-DS) technique cascaded between the mixer’s transconductance and switching stage. The high gain and stability of amplifiers in the transconductance stage of the mixer are achieved using novel tunable capacitive cross-coupled common source (TCC-CS) transistors. Using the I-DS, the third-order non-linear coefficient of current is closed to zero, enhancing the linearity. Additionally, a TCC-CS, which is realized by varactors, neutralizes the gate-to-drain parasitic capacitance (Cgd) of transistors in the transconductance stage of the mixer and contributes to the improvement of the gain and stability of the mixer. The measured 1 dB compression point OP1dB of the designed mixer is 4.1 dBm and IP1dB is 0.67 dBm at 24 GHz. The conversion gain of 4.1 dB at 24 GHz and 3.2 ± 0.9 dB, from 20 to 30 GHz is achieved in the designed mixer. Furthermore, a noise figure of 3.8 dB is noted at 24 GHz. The power consumption of the mixer is 4.9 mW at 1.2 V, while the chip area of the designed mixer is 0.4 mm.

Highlights

  • Published: 12 September 2021In recent studies, the demand for 5G communication systems was shown to have enormously increased

  • The 5G system is becoming a necessity in wireless communication [1,2]

  • The up-conversion mixer is fabricated in 65 nm CMOS technology and the operating characteristics of the mixer are simulated and measured

Read more

Summary

Introduction

The demand for 5G communication systems was shown to have enormously increased. There are many 5G mobile communication devices available; some of them are wireless broadband internet, cellular phones, etc. Low voltage and highly linear RF circuits attract considerable attention in regard to prolonging the battery life of communication systems. The 5G system is becoming a necessity in wireless communication [1,2]. Existing technologies, including LTE and 4G mobile communications, cannot satisfy the increasing demands for a fast data rate, low latency and larger capacity. The 5G system is 1000 times faster than 4G technology. Many advanced communication applications require a high capacity, high data rate communication system, and the 5G technologies fulfill these requirements

Objectives
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call