Design and Analysis of a DC Solid-State Circuit Breaker for Residential Energy Router Application

Abstract

Energy routers act as an interface between the distribution network and electrical facilities, which meet the requirements of clean energy substitution and achieve the energy sharing and information transmission in the energy network. However, the protection of the dc load side of residential energy routers including interruption and isolation of short-circuit fault currents is vital for discussion. Since the traditional mechanical and hybrid circuit breakers for dc fault protection have the drawback of slow operation, a solid-state circuit breaker (SSCB) is an optimal solution for fast dc fault interruption. In this paper, a dc SSCB is proposed that uses an RCD + MOV snubber circuit, which is considered the best and most complete circuit used in common SSCBs. There are two main contributions in this paper: First, a dc SSCB is designed, which isolates both positive and negative terminals of a circuit and its working principle and operating modes along with the formulas for calculation of crucial time intervals, voltages, and currents along with the design procedure are provided. Second, a soft turn-on auxiliary is designed to prevent a high current surge caused by the capacitance difference between the source and the load. The experimental results demonstrate the proper performance of the topology and the validity of the findings.