Abstract
This paper presents the development of a control and validation hardware for neonatal incubators. The developed circuit is installed in the incubator located in the Electrical Engineering Course’s Laboratory of Control of the Federal University of Piauí - UFPI, and constitutes an important dynamic system for the development of control and data processing techniques for undergraduate and masters courses, focusing on the disciplines of Control, Instrumentation and Automation. The prototype created takes into account the requests of the IEC 60601-2-19 standard about the minimum requirements for hardware safety certification and equipment control for incubators. This project presents as result, two circuits, one being responsible for the processing and data acquisition and the other the control drive of the heating load. In addition, this work contains photos, schematics and graphics related to the system created
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Revista Principia - Divulgação Científica e Tecnológica do IFPB
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
