Abstract
The cooling water system of a chemical plant of Akzo Nobel is a partly open system. The site is located at the North Sea. The air in contact with the cooling water contains seawater droplets dissolving and increasing the chloride concentration. The cooling water contains chromate to protect the installation for corrosion. Nevertheless, the chloride concentration in the cooling water may not exceed 50 ppm. To maintain a constant chloride concentration level, a part of the cooling water should be drained and replaced by de-mineralized water. However, the drainage of chromate is limited by governmental regulations. This paper describes a systematic approach from problem definition to the membrane process design encompassing membrane module pre-selection, lab-scale proof of principle and on-site pilot demonstration, the latter to characterize the fouling and scaling potential of the feed solution. Finally, the paper discusses various membrane process design options.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.