Deposition of n-Type Bi2Te3 Thin Films on Polyimide by Using RF Magnetron Co-Sputtering Method

Abstract

Bi2Te3 thermoelectric thin films were deposited on the flexible polyimide substrates by RF magnetron co-sputtering of a Bi and a Te targets. The influence of the substrate temperature and RF power on the microstructure, chemical composition, and the thermoelectric properties of the sputtered films was investigated by using scanning electron microscopy, X-ray diffraction, energy dispersive X-ray spectroscopy, and in-plane resistivity/Seebeck coefficient measurement. It was shown that the thermoelectric properties of the films depend sensitively on the Bi/Te chemical composition ratio and the substrate temperature, and the layered structure was clearly observed from the cross section of the (00L)-oriented, nearly stoichiometric Bi2Te3 films when the substrate temperature is higher than 250 °C. As-deposited Bi2Te3 films deposited at 300 °C show the highest power factor of 0.97 mW/K(2)m and the Seebeck coefficient of -193 μV/K at 32 °C, which also have (00L) preferred orientation and the layered structure. The durability of the Bi2Te3 films on polyimide against repeated bending was also tested by monitoring the film resistance, and it was concluded that the Bi2Te3 films are applicable reliably on the curved surfaces with the radius of curvature larger than 5 mm.