Abstract
IntroductionThe treatments for which mineral trioxide aggregate (MTA)-based materials can be used in dentistry are expanding. Smaller particle size and easier handling properties have allowed the advent of tricalcium silicate sealers including EndoSequence BC Sealer (Brasseler USA, Savannah, GA), QuickSet2 (Avalon Biomed, Bradenton, FL), NeoMTA Plus (Avalon Biomed), and MTA Fillapex (Angelus, Londrina, Brazil). The objective of this study was to measure the tubule penetration with these sealers using continuous wave (CW) and single-cone (SC) obturation techniques. MethodsEighty single-rooted teeth were randomly divided into 8 groups of 10 and obturated with 1 of the previously mentioned sealers mixed with trace amounts of rhodamine using either the CW or SC technique. Teeth were sectioned at 1 mm and 5 mm from the apex and examined under a confocal laser microscope. The percentage of sealer penetration and the maximum sealer penetration were measured. ResultsThe tricalcium silicate sealers penetrated tubules as deep as 2000 μm (2 mm). The percentage of sealer penetration was much higher 5 mm from the apex, with many specimens having 100% penetration for both SC and warm vertical techniques. MTA Fillapex, a resin-based sealer with less than 20% MTA particles, had significantly greater tubule penetration with a warm vertical technique versus the SC technique at the 1-mm level. ConclusionsWithin the limitations of this study, the CW and SC techniques produced similar tubule penetration at both the 1-mm and the 5-mm level with the tricalcium silicate sealers BC Sealer, QuickSet2, and NeoMTA Plus.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.