Densification kinetics of porous colloidal P 2O 5-doped silica gels using constant heating rate measurements

Abstract

Commercially available fumed colloidal silica was gelled in an aqueous solution containing PO 4H 3. Instantaneous gelation was obtained by adding several drops of HF (48 wt%). The objective of this paper was to study the gel-to-glass conversion of these colloidal gels using constant heating rate (CHR) experiments. Gel densification was measured at temperatures ranging from 50 to 1550°C at different heating rates (1 to 10°C/min) using a dilatometer. Shrinkage and shrinkage rate as a function of temperature were measured and CHR equations were used to derive information on the densification mechanisms. The experimental results show that small additions of PO 4H 3 into pure silica dispersions give rise to gels which densify to high silica glass at much lower temperatures than pure colloidal silica gels. The bloating effects produced by pure colloidal silica gels at temperatures above 1280°C were also eliminated. For these P 2O 5-doped silica gels maximum shrinkage rates were found at temperatures between 1050 and 1150°C according to the heating rate used. The CHR analysis showed that several different mechanisms seem to operate in a complex interdependence in the whole range of temperature studied. This CHR analysis was compared with those results obtained from isothermal shrinkage experiments in the range where viscous sintering is the predominant shrinkage-controlling mechanism (between 1000 and 1100°C).