Abstract
AbstractThis paper has as main objective to investigate the influence of nickel (Ni), iron (Fe) and copper (Cu) addition on the tantalum (Ta) powder processing, by promoting a liquid phase sintering (LPS). The role of these metals is to lower the Ta sintering temperature, maintaining good densification and mechanical properties.Ni, Fe and Cu 1wt% additions to Ta powder were performed. Samples were cold pressed at 350 MPa. Sintering was carried out at 1300 to 2000 °C, for 1 hour, under a vacuum of 10‐6 Pa. Density, linear shrinkage and activation energy were measured and calculated. Hardness and compression tests were also conducted. Ni was the most promissing Ta LPS activator, once it enabled the best results of densification and mechanical properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
