Abstract
In the present research paper modeling principles for the oil-water separation with special emphasis on the modeling of dense packed layer (DPL) is presented. Formation of the DPL is attributed to the difference between sedimentation rate and interfacial coalescence rate. Different submodels resolving for the free sedimentation zone, the DPL, the binary coalescence, and the interfacial coalescence are described. These submodels are implemented in commercial CFD software. Adequate validation and calibration of these submodels are necessary to be used for understanding the separation processes in industrial separators. Experiments for understanding the water-in-oil separation processes in a horizontal continuous separator were designed and carried out. Results from bottle and decay tests were used only for calibrating the model. CFD simulations using the calibrated model have served to understand the flow phenomena occurring inside the horizontal separator. The prediction of the model seems to be satisfactory except at higher emulsion flow rate and lower water cuts.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.