Dense and hard TiWC protective coatings grown with tungsten ion irradiation using WC-HiPIMS/TiC-DCMS co-sputtering technique without external heating

Abstract

Titanium tungsten carbide (TiWC) coatings are deposited by a combined high-power impulse and dc magnetron co-sputtering (HiPIMS/DCMS) technique. No external heating is applied during deposition phase, instead, the thermally driven adatom mobility is substituted by heavy ion irradiation. DCMS sources equipped with titanium carbide targets provide constant neutral fluxes to establish the predominant coating structures, whereas tungsten carbide target in HiPIMS mode serves as the source of heavy metal-ions. Substrate bias of −60 V is synchronized to W+ ion-rich time domains of HiPIMS pulses to minimize the contribution from working gas ions. The influence of W+ ion flux intensity, controlled by varying peak target current density (JT), on film properties is investigated. X-ray photoelectron spectroscopy reveals the presence of over stoichiometric carbon forming an amorphous phase, the amount of which can be fine-tuned by varying JT. Changes in film composition as a function of JT are explained based on the in-situ ion mass spectroscopy analyses. Dense TiWC coatings by hybrid process exhibit hardness higher than 30 GPa, which are comparable to TiWC films deposited by DCMS with dc substrate bias and external heating. The relative energy consumption in the hybrid process is reduced by 77 % as compared to high-temperature DCMS processing.