Demineralization effects on physicochemical and combustion characteristics of biomass: Insights into distributed kinetics, flue gas evolution, and slag formation

Abstract

Biomass as the only carbon-bearing renewable energy has enormous potential to challenge the established energy structure dominated by fossil resources, and incineration technology is one of the most direct and efficient pathways for utilizing biomass resources, unfortunately enduring the inevitable sintering and slagging problems owing to the excessive alkali metals. Herein, we comparatively investigated the effects of five leaching solvents (water, acetic acid, wood vinegar, hydrochloric acid, and oxalic acid) on the physicochemical properties and ash-removal capabilities of wheat straw (WS) and rice husk (RH), with a view to achieving better performance in the subsequent combustion characteristics, kinetic examination, flue gas, and slag evolution. Results indicated with ionization ability increased (water < acetic acid < hydrochloric acid), the WS exhibited a strong demineralization performance (maximum 61.1%), further leading to a steep weight loss in its combustion characteristic curve at approximately 350 °C and a delayed peak temperature after the removal of alkali metal. Multiple distributed activation energy model and sensitivity analysis revealed that leaching pretreatment enhanced the activation energy (189–191.8 kJ mol−1) and optimized energy distribution at the preliminary stage of the combustion reaction. In addition, the absence of alkali metals suppressed the catalytic oxidation reaction in the flue gas, remarkably limiting the formation of CO2 but facilitating the release of CO and CH4. Meanwhile, a considerable optimal in biomass ash slagging, in which the initial temperature of the liquid phase slag for WS ash increased to 991 °C. Notably, HCl showed the strongest demineralization performance among the five leaching solvents during pretreatment, but the high-temperature slag content was still higher than that of acetic acid. Therefore, slagging performance is not only associated with the demineralization ability of leaching solvents, but also with ash composition.