Abstract
This article will demonstrate which demands are required from process energy sources (PES), if the non-conventional machining procedures EDM (Electrical Discharge Machining) and ECM (Electrochemical Machining) are efficiently used for the micro machining. Due to the very low working gap, the process conditions are considerably changed compared to the previous machining conditions. The well known PES-concepts can no longer be treated without paying attention to the supply parameter (feeder parameters) and the gap parameter. A very efficient machining procedure is the μ-PECM, which uses the charge reversal of double layers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have