Delayed Photo-activation Effects on Mechanical Properties of Dual Cured Resin Cements and Finite Element Analysis of Shrinkage Stresses in Teeth Restored With Ceramic Inlays.

Abstract

The aim of this study was to investigate the effect of delayed photo-activation on elastic modulus, Knoop hardness, and post-gel shrinkage of dual cure resin cements and how this affects residual shrinkage stresses in posterior teeth restored with ceramic inlays. Four self-adhesive (RelyX Unicem, 3M ESPE; GCem, GC; MonoCem, Shofu; and seT, SDI) and two conventional (RelyX ARC, 3M ESPE; and AllCem, FGM) dual cure resin cements for cementing posterior ceramic inlays were tested. Strain gauge and indentation tests were used to measure the post-gel shrinkage (Shr), elastic modulus (E), and Knoop hardness (KHN) when photo-activated immediately and 3 and 5 minutes after placement (n=10). Shr, E, and KHN results were analyzed using two-way analysis of variance followed by Tukey honestly significant difference post hoc tests (α=0.05). The experimentally determined properties were applied in a finite element analysis of a leucite ceramic inlay (Empress CAD, Ivoclar Vivadent) cemented in a premolar. Modified von Mises stresses were evaluated at the occlusal margins and cavity floor. Shr, E, and KHN varied significantly among the resin cements (p<0.001). Highest overall Shr values were found for RelyX Unicem; GCem had the lowest. Increasing the photo-activation delay decreased Shr significantly. Delayed photo-activation had no effect on E (p=0.556) or KHN (p=0.927). RelyX Unicem had the highest E values; seT and MonoCem had the lowest E values. AllCem and RelyX Unicem had the highest KHN and MonoCem had the lowest KHN. Cements with high Shr and E values caused higher shrinkage stresses. Stresses decreased with delayed photo-activation for all cements. KHN and E values varied among the different resin cements. Residual shrinkage stress levels decreased with increasing photo-activation delay with all resin cements.