Dehydrocyclization of Alkanes Over Zeolite-Supported Metal Catalysts: Monofunctional or Bifunctional Route

Abstract

The direct catalytic conversion of alkanes into aromatics has found potentially important industrial applications. Initially only alkanes with 6 and more carbon atoms in the chain were concerned. Supported platinum catalysts were found active for the aromatization of alkanes; the drawbacks of these catalysts were their deactivation with time on stream and the existence of simultaneous parallel reactions. Much discussion has been published on the aromatization of C6+ alkanes. A bifunctional mechanism which involves both the metal and the acid sites of the support and a monofunctional mechanism involving only the metallic sites operate over, respectively, Pt supported on acidic support and Pt supported on nonacidic support. In the present review the mechanisms proposed for the aromatization of alkanes are described. Over monofunctional Pt catalysts two possible mechanisms prevail: 1,6 ring closure on the Pt surface involving primary and secondary C-H bond rupture, followed by dehydrogenation of the cycloalkanes into aromatics (1,5 ring closure to a lesser extent also contributes to aromatic production); or dehydrogenation of the alkanes into olefins, dienes, and trienes followed by thermal ring closure. Zeolites were found most suitable as support for preparing catalysts more active and more selective in the alkane aromatization. In addition catalysts based on noble metals supported on zeolite appeared more resistant against deactivation by coke. In this review the aromatization of hexane, heptane, and octane over Pt-zeolite catalysts is discussed in detail. Comparisons between different zeolite structures and different dehydrogenation sites are given. In particular a critical analysis of the results and interpretation concerning Pt-KL catalysts strongly suggests that the exceptional high selectivity towards aromatization of n-hexane exhibited by Pt-KL could not be explained by only the nest or constraint effect exerted by the channel dimension and morphology, not by only the terminal cracking properties, not by only the partial electron transfer from the zeolite support to the Pt particles, and not by only the Pt particle size. Zeolite structure also affects the aromatic product distribution, in particular when the alkane contains more than 7 carbon atoms. It is shown how Pt on medium-pore zeolites such as In-ZSM-5, silicalites will favor the aromatization of C8 alkane isomers into ethylbenzene-styrene with respect to other C8 aromatics. Aromatization of light alkanes, C2-C5, requires the increase of the hydrocarbon chain length up to 6 carbon atoms and higher, followed by cyclization reaction. Recently new processes to convert C2-C5 alkanes into aromatics have been disclosed, M2-forming from Mobil, Cyclar from BP-UOP, and Aroforming from IFP-Saluted. In general these processes use bifunctional catalysts possessing a dehydrogenating and an acid function. The catalysts consist of a metal ion or metal oxide supported on a microporous acid solid. In this review we analyze the results concerning mainly platinum supported on pentasil-type zeolite. It is shown that althoug Pt has better dehydrogenating properties as compared with gallium and zinc, the efficiency of catalysts based on Pt-ZSM-5 for light alkane aromatization is less because undersirable reactions such as hydrogenolysis and ethene (olefins) hydrogenation occur on the platinum surface, resulting in the production of unreactive alkanes, CH2, C2H6. These drawbacks could be partially suppressed by alloying Pt and by increasing the reaction temperature.