Degradation Studies of Thermoplastics Composites of Jute Fiber–Reinforced LDPE/Polycaprolactone Blends

Abstract

This article reports the fabrication, properties, and degradation studies of jute fiber–reinforced thermoplastic polymers. One of the non-traditional outlets of jute fiber is in the area of fiber-reinforced composites. However, the major drawback associated with the application of jute fiber for this purpose is its high moisture regain. To impart hydrophobicity to the fibers and to concomitantly increase interfacial bond strength, which is a critical factor for obtaining better mechanical properties of composites, jute fibers were treated with benzoylchloride, Y-glycidoxytrimethoxysilane, and neo-alkoxy-tri(N-ethylenediamino)ethyltitanate. Such a treatment resulted in an increase in the diameter and denier of the treated fibers, and deterioration in the mechanical properties was observed. SEM studies revealed an increase in surface roughness after titanate and alkali treatment, which in turn increases interfacial bond strength. A series of low-density polyethylene (LDPE) blends with 5–20% (w/w) of poly(e-caprolactone) (PCL) and with/without treated and untreated jute fibers were prepared by using a single-screw extruder. LDPE modified by blending with PCL (80:20, wt/wt) was used as a thermoplastic matrix. Composites were fabricated by using 1-cm-long jute fibers; the weight fraction of unmodified fibers, silane-treated fibers, and titanate-treated fibers was varied from 0.05 to 0.13. An increase in weight fraction of fibers resulted in an increase in tensile strength and modulus and decrease in elongation at break. Thin sheets and dumbbells were used for enzymatic degradation tests. The degradation of the material was monitored by weight change and loss of mechanical properties. The enzymatic degradation in the presence of Pseudomonas cepacia lipase gave appreciable weight loss in PCL and blended materials.