Deformation of poorly consolidated sediment during shallow emplacement of a basalt sill, Coso Range, California

Abstract

A 150-m-long, wedge-shaped unit of folded and faulted marly siltstone crops out between undeformed sedimentary rocks on the north flank of the Coso Range, California. The several-meter-thick blunt end of this wedge abuts the north margin of a basaltic sill of comparable thickness. Chaotically deformed siltstone crops out locally at the margin of this sill, and at one locality breccia pipes about one meter in diameter crosscut the sill. The sill extends about 1 km south up the paleoslope, where it merges through continuous outcrop with a lava flow that in turn extends 1.4 km to a vent area marked by more than 100 m of agglutinate and scoria. Apparently, lava extruded at this vent flowed onto unconsolidated sediments, burrowed into them, and fed a sill at about 40 m depth within the sedimentary sequence. The sill initially propagated by wedging between sedimentary beds, but eventually began to push some beds ahead of itself, forming a remarkable train of folds in the process. The sediments apparently were wet at the time of sill emplacement, because hydrothermal alteration is common near the contact between the two rock types and because the breccia pipes that crosscut the sill apparently resulted from phreatic explosions of pore water heated at the base of the cooling sill. Comparison of deformation of the host material at the Coso locality with that reportedly caused by emplacement of sills elsewhere indicates that the character of deformation differs greatly among the various localities. The specific response of host material depends upon such parameters as initial properties of magma and host material, rate of sill growth and attendant rate of strain of host material, and depth of sill emplacement. Some properties may change considerably during an intrusive-deformational episode, thus complicating accurate reconstruction of such an event.