Abstract
Zinc-based coatings are widely used for protection against corrosion of steel-sheet products in the automotive industry. The objective of the present article is to investigate the deformation modes at work in three different microstructures of a thin (8 µm) zinc coating on an interstitial-free steel substrate under tension, plane-strain tension, and expansion loading. Damage mechanisms are addressed in a companion article. The plastic slip and twinning activity in the zinc grains of an untempered cold-rolled coating (labeled NSK), a tempered cold-rolled coating (labeled SK), and a recrystallized coating are compared with the response of the corresponding bulk low-alloyed zinc material. The in-plane grain size in the NSK and SK coatings ranges from 300 to 600 µm, vs about 30 µm in the recrystallized coating and bulk material. The coatings exhibit a strong crystallographic texture, with the c-axis generally normal to the sheet plane. Basal slip is shown to be the main deformation mechanism in bulk zinc and the recrystallized coating, whereas pyramidal π2 slip and mechanical twinning are found to be major modes in the NSK and SK coatings. These results, obtained from an extensive, quantitative slip-line analysis combined with electron backscattered diffraction (EBSD) measurements, are explained by the constraining effect of the substrate. This effect is successfully modeled using a simple Taylor-like polycrystalline approach. The recrystallized coating behaves much like the bulk material. The interpretation of this grain-size effect between the NSK and SK coating, on the one hand, and the recrystallized coating, on the other hand, requires a full three-dimensional finite-element analysis of the multicrystalline coating provided in this work. The simulations show that strong strain gradients can develop in the recrystallized coating from the interface to the surface, which is not the case in the NSK and SK coatings.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
