Abstract
This paper presents the modeling, design, fabrication and testing of monolithic electrostatic curved-electrode zipping actuators fabricated by deep reactive ion etching (DRIE). In contrast to traditional curved-electrode zipping actuators, the design of the actuators presented here utilizes a compliant starting cantilever to significantly reduce the initial pull-in voltage by closing the gap (kerf) generated by DRIE. Thus, the actuators achieve high actuation force at a relatively low voltage. For example, two actuators each with dimensions of 4.5 mm*100 /spl mu/m*300 /spl mu/m are used to drive a bistable MEMS relay. Together, the two actuators provide up to 10 mN of force over their 80 /spl mu/m stroke at 140 V. Measurements of the force-displacement relation of these actuators confirm theoretical expectations based both on numerical and analytical methods. Finite element analysis is employed to predict the behavior of the complete bistable relay system. [1231].
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.