Deep‐drawing quality of cold rolled sheet made of ferritically rolled hot strip

Abstract

In the so‐called ferritic rolling the finishing is shifted down into the temperature region of ferrite, which enables a production of thinner hot strips (compared to the conventional hot rolling in austenite) with a changed texture development. The present study is focused on the effect of the process parameters of such initial warm rolled hot strips on the texture formation and hence on the deep‐drawing quality of the final cold strips. A special attention is given to the transmission of the hot strip texture to the cold strip. The investigation was carried out on commercial IF‐ and ELC‐steels by a laboratory simulation with the hot deformation simulator Wumsi (rolling simulated by the plane strain compression test). It was possible to optimize cold rolling and subsequent annealing by means of the measurements of the texture development during the ferritic (warm) deformation as well as the parameters of the processing route of such special production of cold strips by means of the calculation of r‐values. If compared with the conventional processing route, a considerable improvement of deep‐drawability with a diminished earing is achievable especially with the IF‐steel.