Abstract
The application of Maslennikov’s technique for the very deep drawing of sheet metals is considered in this chapter. This process employs a rubber ring instead of a rigid punch and applies the forming pressure by repeated compression of the ring. The effects of forming parameters such as ring thickness, ring hole diameter, die hole diameter, and die profile radius on the process are discussed in detail. An analysis of Maslennikov’s process is also presented. The chapter continues with a brief introduction to collar drawing and redrawing with rubber rings using the same concept as applied in Maslennikov’s technique.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
