Abstract
Abstract. Almost always noise figure is measured today by using a matched noise source delivering two different but known noise temperatures (Y factor method). In commercially available noise sources these temperatures are characterized by the excess noise ratio (ENR) value, describing the ratio of equivalent noise power when switched on related to the noise power of a resistor at a temperature of 290 K (switched off). For a typical ENR value of 5 dB that means a hot temperature Th=1207 K and a cold temperature Tc = 290 K.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
