Abstract
Micro-Doppler time-frequency analysis has been regarded as an important parameter extraction method for conical micro-motion objects. However, the micro-Doppler effect caused by micro-motion can modulate the frequency of lidar echo, leading to coupling between structure and micro-motion parameters. Therefore, it is difficult to extract parameters for micro-motion cones. We propose a new method for parameter extraction by combining the range profile of a micro-motion cone and the micro-Doppler time-frequency spectrum. This method can effectively decouple and accurately extract the structure and the micro-motion parameters of cones. Compared with traditional time-frequency analysis methods, the accuracy of parameter extraction is higher, and the information is richer. Firstly, the range profile of the micro-motion cone was obtained by using an FMCW (Frequency Modulated Continuous Wave) lidar based on simulation. Secondly, quantitative analysis was conducted on the edge features of the range profile and the micro-Doppler time-frequency spectrum. Finally, the parameters of the micro-motion cone were extracted based on the proposed decoupling parameter extraction method. The results show that our method can effectively extract the cone height, the base radius, the precession angle, the spin frequency, and the gravity center height within the range of a lidar LOS (line of sight) angle from 20° to 65°. The average absolute percentage error can reach below 10%. The method proposed in this paper not only enriches the detection information regarding micro-motion cones, but also improves the accuracy of parameter extraction and establishes a foundation for classification and recognition. It provides a new technical approach for laser micro-Doppler detection in accurate recognition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.