Abstract
The adsorption and decomposition of methanol, ethanol, propan-1-ol, propan-2-ol and butan-1-ol has been studied on clean, and oxygen pre-covered Pt(111) surfaces. Temperature Programmed Reaction Spectroscopy (TPRS), Surface Potential Measurements (ΔV), UPS and XPS were used to characterise the adsorbed layer as a function of temperature. Each alcohol adsorbed into two states, a monolayer phase and a multilayer phase which were distinguishable by TPRS and Spectroscopy measurements. The monolayer alcohol adsorption heats increased sequentially from methanol to n-butanol (11.5–15 kcal mole −1). On the clean surface, less than 10% of the adsorbed monolayer dissociated, with 90% of the alcohol desorbing intact. Two competing dissociative pathways were observed: complete dissociation to adsorbed CO, H and C, and with propan-1-ol and butan-1-ol, scission of the CC bond nearest the CO group to form adsorbed CO, H and ethylidyne and propylidyne species respectively. The latter reaction probability was constant at 30% for n-propanol and n-butanol. In all cases the final desorption products were the parent alcohol, CO and H 2 with carbon remaining on the surface for the higher alcohols. Atomic oxygen removed hydrogen from the alcohols as water but did not change the final reaction products.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.