Abstract

The xylene decomposition system which consists of adsorption process by adsorbents and adsorbed xylene decomposition process using nonthermal plasma with gas circulation is investigated. Two types of hydrophobic zeolite pellets are used as adsorbent. The ac 60 Hz and 20 kHz high voltage power supplies are employed for nonthermal plasma generation. After p-xylene or xylene mixture which consists of o-, m- and p-xylene is adsorbed by adsorbent for 130 min, nonthermal plasma is generated in order to decompose adsorbed xylene with gas circulation. For p-xylene, the conversion ratios of adsorbed xylene to CO and CO2 (etacox) reach 43% for ac 60 Hz plasma and 70% for ac 20 kHz plasma during 60 min treatment and then the energy efficiencies (Ed) are 0.26 and 0.75 g/kWh, respectively. As for xylene mixture, etacox of 69 and 48% are obtained by ac 60 Hz plasma for 90 min and ac 20 kHz plasma for 75 min, and Ed are 0.27 and 0.43 g/kWh. Ac 20 kHz plasma is better energy efficiency than that of ac 60 Hz plasma, however, ac 20 kHz plasma is unstable and generates NOx as byproduct. From FTIR analysis of exhaust gas after treatment, it is clarified that N2O is generated by ac 60 Hz plasma.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.