Abstract
ABSTRACT Degradation by wood-rotting fungi has been studied in Lignamon and beech wood modified by the Lignamon process. Different treatments that are used during Lignamon process were applied: gaseous ammonia treatment, densification (20 and 40% compression ratio) and heat treatment (180°C). These specimens were exposed to Trametes versicolor and Coniophora puteana for 16 weeks and the mass loss was evaluated. Changes in chemical structure, nitrogen content and pH caused by individual treatments or by fungal activity were also determined. The wood nitrogen content increased after ammonia treatment (1.0%) and was the highest in Lignamon (1.4%), its release during water leaching was very slow. The chemical analysis of wood revealed slight changes in the polysaccharide and lignin content in wood treated with ammonia. Bonded nitrogen was in the form of amides, which were partially thermally degraded by heat treatment. Neither densification nor heat treatment led to better resistance of wood against fungi, while ammonia treatment significantly restricted mass losses (C. puteana 2.5%; T. versicolor 7.5%) compared to untreated wood (both about 30%). Lignamon showed the best fungi resistance (mass loss < 5%), which was probably caused by the combined effect of hemicellulose degradation, an increased nitrogen content, and wood densification.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.