Abstract
We propose a simple DC voltage sensor-less single phase PFC converter by detecting an AC line voltage waveform. Any DC voltage and AC current sensors used in the conventional PFC converter are not required to construct the control system. The conventional converter circuit with a boost chopper circuit in the DC side from a rectifier circuit is used as the main PFC converter circuit. In the control system, the circuit parameters such as a series inductance L and equivalent load resistance value R are used to generate the sinusoidal current waveform. The DC voltage is directly controlled by the command input signal k/sub d/ (E/sub d//E/sub a/) for the boost chopper circuit. The DC voltage regulation is small because of the feedforward control for the AC line voltage E/sub a/ and no dependence of the circuit parameters. The sinusoidal current waveform in phase with the AC line voltage can be obtained. The feasibility of the proposed control system is verified by some simulation and experimental results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
