DC Magnetron-Sputtered Mo Thin Films with High Adhesion, Conductivity and Reflectance

Abstract

The main challenge in the deposition of molybdenum thin films for high efficiency in copper indium gallium selenide (CIGS) modules lies in gaining an adherent coating without compromising conductivity and reflectance characteristics. In this study, Mo thin films were deposited on soda-lime glass by DC magnetron sputtering at different deposition power (55, 100, 200 and 300 W) and with high working gas pressure (2 and 4 Pa). Analytical techniques such as X-ray diffraction (XRD), scanning electron microscopy (SEM) and Hall effect were employed to analyze the structure, morphology and electrical resistivity of the deposited films. Ultraviolet–visible (UV–Vis) spectrometry was performed to measure the reflectance and a cross-hatch adhesion tape test was employed to determine the adhesion behavior of deposited films. With higher sputtering power and reduced gas pressure, an increase in the crystallite size of the deposited films was observed. Films deposited at higher gas pressure were found with tensile stresses and higher adhesion with the substrate. The van der Pauw method reveals an increase in conductivity at high power and low gas pressure. Improved reflectance was achieved at moderate sputtering power and low gas pressure.