Abstract
<span>This paper is about preparation of silicone rubber (SiR) samples with different filler for high-voltage insulation purpose. The fillers used were silica from waste glass, calcium carbonate from cockle shell, silica/calcium carbonate and wollastonite. All the fillers were crushed into powder and undergo internal mixer and hot press as a material preparation. It was expected that the combination of filler with silicone rubber would give better result when experiencing ageing process. The direct current (DC) inclined plane test was used to investigate the tracking and erosion on silicone rubber composites. The tracking length was observed between the top and bottom electrode. Comparison would then be made between the silicone rubbers with different fillers based on the result obtained from the experiment.</span>
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Indonesian Journal of Electrical Engineering and Computer Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
